Established since 2011
Registered Member of the IKGH
Fan Tail.
Dorsal Fin
The dorsal fin shall be slim, rising steeply in the beginning and reaching
a point up to the end of the first third of the caudal fin.
Evaluation of the length:
Up to the end of the first third of the caudal ……..……….……………….5 points
Up to the caudal fin beginning ………….……...………….………………. 3 points
Less than up to the caudal fin beginning………………….……...…...1 to 2 points
Dorsal fin reaches beyond the first third of the caudal ….…deduct up to 3 points
Examples of point deductions for formal defects
Not steeply rising at beginning ……….……deduct up to 3 points
Strong serrations or defects …………...….deduct up to 2 points
Deviation from the ideal shape ……….…...deduct up to 7 points
The total of the points deducted shall not exceed 8.
The deduction for the same defect is only allowed once.
Caudal Fin
The caudal fin has an elongated triangle form with an angle of
45 degrees to the body.
The ideal length of the caudal fin shall be 10/10 of the body length.
The edges of the caudal fin shall be straight, but the corners can be
slightly rounded.
Evaluation of the length
10/10 of the body length ………………………….…...… 10 points
8/10 of the body length ……………………………....…… 8 points
7/10 of the body length ……………………………....…….5 points
6/10 of the body length ……………………………....…….2 points
Less than 6/10 of the body length ……………..…...…….no points
More than 10/10 of the body length …………deduct up to 3 points
Examples of point deductions with defects and spreading
Angle: 45 degrees …………..……………...no point deductions
35 degrees ……………………….……....deduct 2 points
30 degrees ……………………….……....deduct 4 points
Fewer than 30 ………………………...………...no points
50 degrees ……………………………….deduct 4 points
More than 50 ………….….……………...deduct 8 points
Rear edge clearly concave or convex …………. deduct up to 2 points
Rear edge runs diagonally ………………………deduct up to 4 points
Rear edge strong serration and/or defect …….…deduct up to 5 points
Upper and lower edges at unequal angles……... deduct up to 5 points
Upper and lower edges concave or convex……..deduct up to 5 points
Upper and lower edges serration or defects….....deduct up to 2 points
Corners rounded off too much ………………… deduct up to 2 points
The total amount of deducted points must not exceed 20.
Ideal Body Size
26mm